View MDS-169_1278292.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

Termination Insensitive Mixer, 1 MHz - 3.5 GHz
Features
* Intermodulation Ratio is Insensitive to Port Mismatches * VSWR: <2.0:1 Typical Midband * Isolation: 35 dB Typical Midband * Impedance: 50 Ohms Nominal * Maximum Input Power: 350 mW Max @ 25C, Derated to 85C @ 3.2 mW/C * LO Power: +24 dBm Max. * MIL-STD-883 Screening Available
MD-/MDC-/MDS-169 V5
FP-2 (MD-169)
Description
The unique design of the termination insensitive mixer (TIM) enables it to apply high reverse voltage to diodes during their "off" phase, in the LO cycle. This allows for higher power level performance with minimum distortion. In addition the TIM has internal loads that provide a good match and also absorb mixer generated LO frequency terms. Combined, these features give the m ixer its insensitivity to external mismatches, plus superior VSWR.
C-7 (MDC-169) SF-1 (MDS-169)
1
M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information.
* North America Tel: 800.366.2266 / Fax: 978.366.2266 * Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 * Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information.
Termination Insensitive Mixer, 1 MHz - 3.5 GHz
Electrical Specifications1: TA = -55C to +85C
Parameter Frequency Range Conversion Loss Test Conditions RF, LO Ports IF Port Frequency 0.001 - 3.5 5 - 1500 5 - 1000 MHz2 5 - 3000 MHz3 1 - 3500 MHz LO to RF LO to IF RF to IF 5 - 1000 MHz 1 - 3500 MHz 5 - 1000 MHz 1 - 3500 MHz 10 - 500 MHz 1 - 3000 MHz 1 - 3500 MHz -- -- -- 10 MHz 500 MHz 3000 MHz -- Units GHz MHz dB dB dB dB dB dB dB dB dB dB dBm dBm -- dB dB dB dB Min -- -- -- -- -- 30 20 30 20 30 20 18 -- -- -- -- -- -- --
MD-/MDC-/MDS-169 V5
Typ -- -- -- -- -- -- -- -- -- -- -- -- +7 +5 -- 55 58 56 3
Max -- -- 7 8 10 -- -- -- -- -- -- -- -- -- -- -- -- -- --
Isolation
RF Input SSB Noise Figure Typical Two-Tone IM Ratio 3rd Order Intermodulation Ratio Degradation
1 dB Compression 1 dB Desensitization Within 1 dB of Conversion Loss Max with a -10 dBm input, each tone 625 MHz and 35 MHz IF @ IF VSWR 3:1
1. All specifications apply when operated at +10 dBm available LO power with 50 Ohm source and load impedance. 2. For IF Frequencies of 5 - 300 MHz and RF of -10 dBm or less. 3. For MDC-169, add 1.0 dB to conversion loss.
Electrical Specifications (MDS-169): TA = -55C to +85C Frequency: RF, LO Ports = 1 - 3500 MHz, IF Port = 5-1500 MHz
Parameter Conversion Loss Test Conditions LO @ +10 dBm IF @ 60 MHz Frequency 5 - 1000 MHz 1000 - 3000 MHz 1 - 3500 MHz 5 - 1000 MHz 1 - 3500 MHz 5 - 1000 MHz 1 - 3500 MHz 10 - 500 MHz 1 - 3000 MHz 1 - 3500 MHz Units dB dB dB dB dB dB dB dB dB dB Min -- -- -- 30 20 30 20 30 20 18 Typ 6.5 7.5 8.0 35 25 35 25 35 25 23 Max 7.0 9.0 10.0 -- -- -- -- -- -- --
Isolation
LO to RF LO to IF RF to IF
2
M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information.
* North America Tel: 800.366.2266 / Fax: 978.366.2266 * Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 * Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information.
Termination Insensitive Mixer, 1 MHz - 3.5 GHz
Pin Configuration (MD-169)
Pin No. 1 2 3 4 Function GND GND GND IF Pin No. 5 6 7 8 Function LO GND GND RF
MD-/MDC-/MDS-169 V5
Pin Configuration (MDS-169)
Pin No. 1 2 Function GND IF Pin No. 3 4 Function LO RF
Absolute Maximum Ratings (MDS-169) 4 Bottom View of SF-1
Parameter Max Input Power Total Power LO Power
5
Absolute Maximum
350 mW Derated at 85oC @ 3.2 mW/oC +24 dBm
4. Operation of this device above any one of these parameters may cause permanent damage. 5. Ambient Temperature (TA) = +25oC
Typical Performance Curves
3
M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information.
* North America Tel: 800.366.2266 / Fax: 978.366.2266 * Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 * Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information.
Termination Insensitive Mixer, 1 MHz - 3.5 GHz
Typical Performance Curves
MD-/MDC-/MDS-169 V5
Ordering Information
Part Number MD-169 PIN MDC-169 SMA MDS-169 Package FP-2 C-7 SF-1
4
M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information.
* North America Tel: 800.366.2266 / Fax: 978.366.2266 * Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 * Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information.

▲Up To Search▲

Price & Availability of MDS-169

	To Download MDS-169 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .